1M10 Adjust

Normally, the natural load line runs approximately 6 cm in front of the ankle joint during relaxed standing. Our engineers have developed an innovative design for the Adjust: A multi-axial joint positioned at the load line.
Thanks to this design, the user is able to maintain a stable standing position – regardless of the proportion of the body weight supported by the prosthesis. Shifting weight from one leg to the other, as well as forward and backward shifts of the body’s weight on the foot, have only a minimal effect on standing stability.

Standing and walking securely require a good foundation, which in turn demands that the foot adapts to the ground. Thanks to its multiaxial joint and the flexibility of the function module and forefoot-ball pad, the Adjust effectively compensates for surface irregularities. This allows the amputee to maintain a stable standing position on a variety of surfaces and easily handle irregularities while walking.

The adjustable function module of the Adjust allows individual heel characteristic requirements to be taken into account when optimizing the prosthesis. The adjustments can be done without the need for alignment changes to the prosthesis. Elaborate, time-consuming trial fittings which are strenuous for the user are reduced.

The Adjust allows for three different configurations: The pre-set configuration 2 provides a moderate heel strike. Configuration 1 provides a soft heel strike and configuration 3 a firm heel strike.